DPF 4500GX is constructed of a 3-mil (75 micron) white calendered film offered in gloss and coated with clear bubble releasing, permanent pressure-sensitive adhesive. The Low Profile X-Scape Technology® allows installers to achieve speedy installation while maintaining high enough tack to ensure long-term bond. The polymeric facestock allows for vibrant prints combined with ease of application for short and medium term graphics. DPF 4500GX is rated for outdoor durability up to 5 years (unprinted). Printed durability is dependent on the ink system used.
|Property||Test Methods||Typical Value|
|Surface Finish||Gloss Meter 60° Reflection||80 to 90 Gloss Units|
|Thickness||Micrometer, Federal Bench Type||3-mil (75 micron)|
|Tensile Strength||Tensile Tester 2-in (51 mm) jaw seperation; crosshead speed of 12 in/min. (5.1 mm/s) 1||13.0 lb/in width 2||2.3 kg/cm width|
|Elongation||Instron Tensile Tester as above||≥ 150%|
|Shelf Life (In Box)||Free from excessive moisture, temperature, direct sunlight||1 year from factory shipment|
|Application Temperature Range||On clean, dry substrate 50°F to 90°F 10°C to 32°C||50°F to 90°F 10°C to 32°C||10°C to 32°C|
|Service Temperature Range||On clean, dry substrate -20°F to 150°F -29°C to 65°C||-20°F to 150°F||-29°C to 65°C|
|Dimensional Stability||Shrinkage After 158°F (70°C), 48 hours aging 25 mils 635 micron||25 mils 635 micron||635 micron|
|Peel Adhesion||PSTC-1, 15 min, RT 70°F (21°C)||2.5 lbs/in||0.45 kg/cm|
|Liner Release||TLMI Release at 90°, 300 in/min (760 cm/min)||60 g/2 in||11.81 g/cm|
The following is made in lieu of all warranties expressed or implied:
All statements, technical information and recommendations published by Arlon relating to Arlon products are based on tests believed to be reliable and within the accuracy of the equipment used to obtain the specific values. Their accuracy or completeness is not guaranteed and Arlon makes no warranty with regard thereto. Seller’s and manufacturer’s only responsibility shall be to replace any quantity of the product proved defective. Seller and manufacturer shall not be liable for injury, loss or damage, direct or consequential, arising out of use or the inability to use the product. Nor shall seller or manufacturer be liable for any costs or expenses incurred in the processing or printing on the product. Before using, user shall determine the suitability of the product for its intended use. User assumes all risk and liability of every nature in connection therewith. No statements or recommendations other than those contained in the technical information published by Arlon shall have force or effect unless contained in an agreement manually signed by the officers of seller and manufacturer.