Tip
#26

Vehicle Surfaces with Complex Channels (#26)

Scope:

Arlon recommends this application technique as the most effective method for installing film graphics over vehicles with complex channeled indentations.

Objective:

To install the film with the least possible tension created at the corners of all complex channel installations.

Materials:

Arlon DPF 6000RP or Series 2100

Application Film or Paper

Heat Gun

Hard Plastic Squeegee

Felt Wrapped Squeegee

Rivet Brush

Puncturing Pin

Graphics

 

Method: These steps should be followed in the order they are presented.

1. Registration

  • Layout all registration marks with release liner attached and place masking tape targets at all important registration marks. Apply hinge strip.
  • Remove upper segment of release liner and begin to apply along the most convenient body contour.
  • Remove all waste film around corners, lighting and fenders to avoid wrinkling. Be sure discarded release liner does not interfere with the footing around the vehicle as it can pose a slip-hazard when left underfoot.
  • For as long as possible allow some release liner to remain on the graphic. This will provide a convenient hand hold for controlling and repositioning the unattached portion of the graphic.

2. Placement of Film on the Flat Segment of Vehicle

  • Move to the top center of graphic and begin squeegee strokes from center to nearest edge in the normal manner. Install entire graphic over the flat and level surfaces first.
  • Once this step is complete remove all masking paper or film. Be careful not to stretch or tear the film bridging over the channels.

3. Channel Placement

  • Begin heating film area over channels until film softens slightly.
  • Using a finger wrapped with soft cotton cloth, a soft cotton glove or a squeegee wrapped with felt, begin to attach film to channel walls while continuing to heat. Begin this segment at areas that will not be stretched, such as the inside of corners (various amounts of heat will be needed to allow stretching over corners and radii). Continuing along the upper edges of all channels on both sides and working from the inside of the corners outward, attach film in overlapping strokes until a uniform line has been established halfway down the vertical sections.
  • Now working on the horizontal surfaces, again using heat to soften the graphic, attach the film to the center of the horizontal channel surface. As before, begin at the center of the curve and work to the outer edges with uniform sweeps of a finger or soft squeegee.
  • Continue using heat to soften and reshape the remaining film on the last half of the vertical walls and horizontal floors of the channel until all film is attached. Regardless of the ambient conditions this application requires the use of a heat gun or propane torch to achieve temperatures above 250°F (120°C) in order to reduce film memory. It is heat which allows film to remain in place once having been stretched.

Don't See What You're Looking For?

Many of these TIPS come from our customer feedback and questions so be sure to reach out to us so that we can help you and in turn help others as well! Arlon Technical Services is here for you.

Contact Customer Service